Know who is using our products:
WC3O
- Bob
|
|
 |
We
have used the HamPlus 8X4 antenna switching system at
Skyview Radio Society for over a year now. We purchased
the switch from DX Engineering in Ohio. The switch has
been a major benefit to our contesting efforts. It allows
up to quickly compare between antennas. Changing band
is now very fast and effortless. When we operate multi-single
we can put one beam to EU, one to SA and one west. Makes
switching directions during gray line a snap! The inter-station
isolation has been great. No problems at all. At Skyview
we do a lot of high power RTTY contesting. The switch
never flinches. The SWR through the switch is great, even
at 28 MHz. The lit buttons allow us to directly mark which
button controls which antenna. Both DX Engineering and
HamPlus have been very helpful with questions with quick
responses. The system is a winner.
Bob Bastone
Radio Officer Skyview Radio Society K3MJW/W3GH
|
 |
W7RN
- Tom
|
|
 |
We
decided to buy the HamPlus equipment because we got such
a great endorsement from my dear friend Oms, PY5EG. We
absolutely could not be more pleased with the HAMPLUS
equipment. It has been working flawlessly. [click
for more]
Tom
Taormina, K5RC
Comstock Memorial Station, W7RN
Storey County ARES, KS7AA
www.w7rn.com
|
 |
PY2YP
- Cesar
 |
I
have two towers in my backyard holding four monobands,
one WARC triband plus an inverted L for 160 meters. To
keep all those antennas and rotators handy and ready I
use one MBD-8E as band decoder, one AS-82 antenna switcher
and one RW-34 as rotator switcher. This setup helps a
lot to quick QSY for new band countries and contest multipliers.
Being a QRO operator I looked for rugged hardware for
automatically controlled operation so Hamplus was my choice.
Cesar,
73 DX de PY2YP
|
PP5AR
- Renato
 |
Here
in my shack, the switch made by Hamplus simplified the
operation allowing fast exchange of antennas with maximum
trustworthiness. These switch are on 24 hours and it
never presented any kind of malfunction or generating
any interference. The signal of two radios with one
linear amplifier (high power) and three antennas are
on in it.
Renato,
PP5AR
|
PY3AT
- Vagner
 |
I
was always capricious with my hamradio equipment and
accessories. The antenna switcher made by Hamplus is
an equipment that deserves prominence for the finishing
international standard and perfect functioning. It makes
the interconnection of all my radios and antennas, all
pass through it. In my opinion, if it is for having
something on of my table, it needs to be excellent quality.
If for this I need to keep money for some months I make
it, but when I buy I want the better.
|
PP5MS
- Marcus
 |
I
have using four switcher´s AS4R made by Hamplus
hardwired in cascade to establish connection and to change
four antennas, two transceivers, a linear amplifier and
a 50 ohms. With this configuration I quickly obtain any
combination without exchange any cables.
Marcus,
PP5MS
|
PP5ABG
- Crestani
 |
I
am using the antenna switcher made by Hamplus for more
than one year to change four antennas with easiness, efficiency
and trustworthiness. I recommend.
Crestani
- PP5ABG
|
PP5JD
- Jaime
 |
I
have used for more than year one antenna switcher made
by Hamplus. I am a contest operator, and use this switch
with a linear amplifier and never had any kind of problem.
I recommend, especially for hams that living in apartments
because it is possible to use with remote control. With
only one coaxial handle in descending and one cable
for command, you can use up to 8 antennas on top of
the building.
|
PP5AFG
- Sady
 |
After
installing the antenna switcher made by Hamplus, the operation
was so simplified that is possible to me to drink a beer
without worrying about change my antennas.
Sady
- PP5AFG
|
PP5CFS - Celso
PP5CGD - Norberto
PY3HAM - Augusto
PY3JH
|
|
